Can’t find what you are looking for? Check your DirectX version, you need to install DirectX 5. We recommend users to install their system from scratch to avoid device conflict. You can idnetify the difference by two ways: We are a board manufacturer, not a distributor.

Uploader: Volkis
Date Added: 25 April 2015
File Size: 9.90 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 42219
Price: Free* [*Free Regsitration Required]

I experienced a “Windows Protection Error” after installing a software on my Windows Is there anyway of overclocking the video on this motherboard? What is the problem? How do you tell the VP and VP apart if you lost the box and m523

Drivers Download: Ali M Usb Taringa

What can I do to fix this? Check your DirectX version, you need to install DirectX 5. Also the OS version and software you used with your device.

Please follow the instructions carefully: The BIOS upgrade can be found in this website. ALi recommend the use of Windows’s default IDE driver if the south bridge you ussb using is one of the following: My system clock seems to be slow or stopped working.


I have disabled my power management in both my BIOS and in Windows but my monitor still goes into Standby mode after being idle for 15 minutes. The manual on page ueb is incorrect.

Re: kern/47717: interrupt problem when starting an Acer Labs M5237 USB ohci controller

My computer constantly locks up or give me the fatal error screen blue screen. Only two beep codes: What is the highest CPU speed and type that this board can take? But the fix is very easy. We will do our best to give a solution to your problem.

How can I get it back? No matter what jumper n5237 I use, it always says MHz. For more information about BIOS upgrade, please contact the motherboard manufacturer. I need an IR port for this board.

I accidentically programmed the BIOS with wrong or bad file, now my system won’t boot.

We will never know the next available BIOS update be. Is this available directly through BCM?

Recent Drivers  4470C XP DRIVER

Re: kern/ interrupt problem when starting an Acer Labs M USB ohci controller

The latest BIOS update is always on our website. Should this board supprt Ultra DMA 66? If it doesn’t solve your problem, try dis-ableing DMA mode within device manager under your disk drive properties. Here is URL address: Is there any driver that would allow this to work? Yes, you can download the latest version of ubs IDE Driver from our website.

Is it a problem with my motherboard? Not just voltage, but bus clock speed and multiplier as well. Refer to Jumper section for this board to get a correct jumper setting.

What is the solution? Only up to Ultra DMA Go to any electronic store like Radio Shack and find CR battery.